BendPak HD-9AE Alignment Lifts 9000 lb

BendPak HD-9AE 4 Post Alignment Lift Features:

9,000-lb. maximum lifting capacity

Multi-caster slip plates

Dual radius plate positions

heavy-duty stainless steel lifting cables

Dual-hub cable sheaves

Grease nipples on every sheave and sheave axle

Single hydraulic cylinder

Integrated hydraulic flow restrictor

Durable powser coat finish

Spring-loaded safety locks

Simple push-button lock release

Aircraft-quality stainless steel and aluminum pneumatic cylinders

Secondary lock system

Fully enclosed cables, airlines, safety latches and sheaves

Multiple adjustable height locking positions

Maintenance-free power system

Easy-to-reach operator controls

Non-skid runways

Multi-position safety locks in each column

Power unit can be located at the front or rear of the lift

Independent "back-up" slack-cable safety latches.

Optional 7000 pound capacity rolling jacks available

BendPak HD-9AE 4 Post Alignment Lift Specifications:

Overall width: 127" / 3,226 mm

Outside length: 198" / 5,029 mm

Overall length: 224" / 5,690 mm

Height of columns: 88" / 2,235 mm

Runway min height: 6-1/2" / 165 mm

Max rise: 70" / 1,778 mm

Max lifting height: 76-1/2" / 1,943 mm

Width between posts: 117" / 2,972 mm

Runway width: 19" / 483 mm

Width between runways: 40" / 1,016

Length of runways: 188" / 4,775 mm

Min. wheelbase @ rated capacity: 135" / 3,429 mm

Min. wheelbase @ 75% capacity: 115" / 2,921 mm

Min. wheelbase @ 50% capacity: 95" / 2,413 mm

Min. wheelbase @ 25% capacity: 80" / 2,032 mm

Locking positions: 12

Lock spacing: every 4" / 102 mm

Lifting time: 60 sec

Motor: 220 VAC / 60 Hz / 1 Ph

BendPak HD-9AE 4 Post Alignment Lift Shipping Info:

Dimensions -

Shipping Weight -

* This dimension may be limited with the addition of rolling jacks. See rolling jack specifications on separate page. ** May vary depending on wheel size. *** Special Voltages Available Upon Request The design, material and specifications are subject to change without notice.

Note: An air supply (minimum: 30 psi / 3 CFM) is required for the safety-lock mechanisms to disengage. It is solely the responsibility of the end-user to provide, install and maintain the air supply.

*Not all BendPak lift models meet the standards as prescribed by ANSI/ALI ALCTV-2006 or ANSI/UL 201. Consult www.autolift.org for a complete list or contact BendPak via contact@bendpak.com.

BendPak HD-9AE Documentation:

BendPak HD-9AE Brochure

BendPak HD-9AE Lift Operating Manual